StarcrownDomes & Zomes
Cart 0

The method

Flat on a jig. Up in rings.

Most domes are struts and steel hubs. Ours are panels: each diamond or triangle framed flat on the ground, the same way every time, then bolted to its neighbours. It's the slow part done where you can reach it.

  1. 01Footings and floor
  2. 02The wall under
  3. 03Build the jig
  4. 04Frame the panels
  5. 05Raise the rings
  6. 06Skin, crown and doors
  1. Fig. 1 · Section through the floor

    Step 01

    Footings and floor

    Piers or a concrete ring, then girders, joists and a ring beam. The guide gives every pier’s position from the centre, and frost depth where it matters.

    Every pier, set out from the centre

  2. Fig. 2 · The wall under, in elevation

    Step 02

    The wall under

    A pony, knee or riser wall sets the shell at a height you can stand under. It is ordinary stud framing on a bevelled base timber cut to the shell’s lean.

    Ordinary studs, a bevelled base

  3. Fig. 3 · Jig for the z3 diamond, Capella Zome 25

    Step 03

    Build the jig

    One jig per panel shape, screwed out of a sheet of plywood. A 12-fold zome cut at row 7 needs seven; the guide draws each one full size in numbers.

    Corners measured off a baseline to 1/16"

  4. Fig. 4 · A z3 panel framed in its jig

    Step 04

    Frame the panels

    Every strut is a square-ended board with a bevel along its edges. Lay four in the jig, glue and screw, and the diamond comes out the same every time.

    Same jig, same panel, every time

  5. Fig. 5 · Raising a 12-fold shell, ring by ring

    Step 05

    Raise the rings

    Panels bolt to their neighbours a ring at a time, from the base up to the crown. Small zomes go up with two people; homes take scaffolding and a few friends.

    Base to crown, a ring at a time

  6. Fig. 6 · Skinned, crowned and doored

    Step 06

    Skin, crown and doors

    Sheathing goes on panel by panel, then membrane and roofing. The star crown is glazed last, and the doorway, landing and steps finish the shell.

    The glazed star goes in last

Checked before it ships

Every part, every joint, every load.

Each plan is a full 3D model before it is a guide. Every part is checked against every other for overlaps, every joint for what bears on what, and the frame as a truss under snow and wind. The cut list and the guide are printed from that model, so the numbers in your hands are the numbers that were checked.

Parts modelled and checked
43,959
Building models
32
Metal hubs
0

That isn't a substitute for your local engineer and building department, who know your site. It means they start from a sound, complete set.

What's in a plan